About Welding Tribe

The welder who runs Welding Tribe

Welding Tribe is a free site of welding guides, charts and calculators. I run it on my own.

Who writes it

I write under the name Randy Williams. It’s a pen name, but the experience behind it is real. I learned to weld at Colombo Dockyard, a shipyard in Sri Lanka, and I’ve been in the trade for 16 years.

A red-hulled ship sitting in a dry dock, with scaffolding along its hull and another vessel behind it
A ship in dry dock at Colombo Dockyard.
A worker in navy coveralls and gloves runs an oxy-fuel track cutting machine along steel flat bar, with sparks falling into a tray
Cutting steel flat bar with an oxy-fuel track cutter.
Welders in coveralls and helmets working on a long steel frame in a large fabrication workshop
Welding and fitting work in the Colombo Dockyard workshop.

How the charts and calculators are made

The charts and calculators use numbers from published sources: the manuals and data sheets of welding machine and filler makers, OSHA rules, AWS standards and the National Electrical Code. Every chart lists its sources, so you can check them yourself.

When I have checked a chart’s numbers myself, the page says so and gives the date. A chart I haven’t checked yet says it was compiled from the published sources listed on it.

Use the numbers as a starting point

Machines, rods and wire differ from one maker to the next. Treat any chart here as a starting point, and follow your machine’s manual. For electrical work, an electrician and your local inspector have the final say.

Ads

The site is free to use and may show Google ads. See the disclaimer and the privacy policy.

Contact

If you spot a mistake or have a question, send it through the contact page.

Welding Tribe is also on Facebook and Pinterest.